Concrete & Masonry

Rebar Calculator

Estimate rebar length for a two-way slab grid.

Use the Rebar CalculatorEstimate rebar length for a two-way slab grid.
⚡ Instant result✓ Free to use↔ Unit friendly

Calculator

● LIVE
Before you calculateMeasure the finished project dimensions. Use manufacturer coverage/yield values where a product-specific value is requested. Results are planning estimates, so verify quantities before purchasing.

How to use this calculator

Enter the requested project measurements using consistent units, then select Calculate. The result is an estimate intended to help with early material planning and budgeting.

Formula

Grid length ≈ number of bars each direction × slab dimensions × waste factor

Example and planning notes

Measure the actual project area carefully and use the product manufacturer's stated dimensions or coverage whenever possible. For projects with cuts, breakage, pattern matching or irregular geometry, include a suitable waste allowance.

Important: Results are estimates. Verify structural, electrical, plumbing, roofing and code-sensitive work with qualified professionals and local requirements.

Frequently asked questions

How accurate is this rebar calculator?

It is a planning estimate based on the values you enter. Product specifications, installation methods, site conditions and local requirements can change the amount you need.

Should I include waste?

Where a waste field is provided, use an allowance appropriate to the material and project. Complex layouts and cuts usually require more allowance.

Can I use this result to order materials?

Use it as a starting point, then verify package coverage, dimensions and supplier recommendations before ordering.

Related concrete & masonry tools

Worked example and practical checks

For a 10 ft × 10 ft grid at 12 in spacing, you need roughly 11 bars in each direction before cover, laps and bends. Structural spacing and bar size require approved plans.

How to use the result responsibly

Use consistent units and check your measurements at the site. Round purchase quantities up to full packs where necessary. This calculator is a planning aid, not a substitute for supplier specifications, site inspection, or a qualified professional where safety and building codes apply.

Use an approved reinforcement layout

Bar spacing and lap lengths change total steel quantity. The calculator is for quantity planning only; bar size, cover and structural layout require a qualified design.