Landscaping & Outdoor

Fence Calculator

Estimate fence materials from run length and post spacing, with planning guidance for posts, sections, gates, corners and waste.

Plan fence panels and postsEstimate fence materials from run length and post spacing, with planning guidance for posts, sections, gates, corners and waste.
⚡ Instant result✓ Free to use↔ Unit friendly

Calculator

● LIVE
Before you calculateMeasure the finished project dimensions. Use manufacturer coverage/yield values where a product-specific value is requested. Results are planning estimates, so verify quantities before purchasing.

How to use this calculator

Measure the total fence run and enter the spacing or section dimensions requested by the calculator. Plan each straight run separately when the layout changes direction. Account for end posts, corner posts and gate openings before finalizing the material order.

Formula

Panels = fence length ÷ panel width; posts ≈ panels + 1 + extras

Example and planning notes

A fence with several corners and gates can require more posts and hardware than a straight run of the same length. Confirm panel width or picket spacing, post-center spacing and gate dimensions before buying. Sloped ground and partial end sections may also change material quantities.

Important: Results are estimates. Verify structural, electrical, plumbing, roofing and code-sensitive work with qualified professionals and local requirements.

Frequently asked questions

How do I estimate fence posts?

Start with the length of each fence run and the intended post spacing. Posts are also needed at ends, corners and gate locations, so the final layout should be checked rather than relying only on a single division.

Should gate openings be included in fence length?

Include gates in the overall layout, but account for their specific width and dedicated posts so you do not also count the opening as a normal fence section.

What happens if the last fence section is shorter?

Most layouts need a partial final section unless the run divides evenly by the chosen spacing. Plan for cutting or adjusting that section while keeping post spacing within the system’s requirements.

Does sloped ground change the material estimate?

It can. Stepped or racked fence layouts may change post positions, panel use and cutting requirements. Check the fence system’s installation guidance for slopes.

Related landscaping & outdoor tools

Worked example and practical checks

For a straight 100 ft fence with posts spaced no more than 8 ft apart, plan for at least 13 intervals and 14 posts if both ends need posts. Gates and corners change the layout.

How to use the result responsibly

Use consistent units and check your measurements at the site. Round purchase quantities up to full packs where necessary. This calculator is a planning aid, not a substitute for supplier specifications, site inspection, or a qualified professional where safety and building codes apply.

Mark gates and corner posts

Measure each straight fence run and plan the gate width separately. Post spacing must fit each run; end posts, corner posts and gate posts may have different requirements.