Concrete & Masonry

Concrete Calculator

Estimate concrete volume for a rectangular pour.

Plan a rectangular concrete pourUse this to estimate ready-mix concrete for slabs, pads and other rectangular pours. Enter finished dimensions, then add a waste allowance for spillage and uneven excavation.
⚡ Instant result✓ Free to use↔ Unit friendly

Calculator

● LIVE
Before you calculateMeasure the finished project dimensions. Use manufacturer coverage/yield values where a product-specific value is requested. Results are planning estimates, so verify quantities before purchasing.

How to use this calculator

Enter the pour length and width in feet and the concrete depth in inches, then select Calculate. The calculator converts the dimensions into volume and reports cubic yards, cubic feet and cubic meters. Measure the actual pour dimensions rather than relying only on nominal plan sizes.

Formula

Cubic yards = L × W × (depth ÷ 12) ÷ 27 × waste factor

Example and planning notes

A rectangular slab’s volume is based on length × width × depth, with the depth converted to the same unit before multiplication. Concrete is commonly ordered by cubic yard, so the calculator converts the finished volume for planning. Excavation variation, uneven subgrade, spillage and supplier practices can affect the amount ultimately ordered.

Important: Results are estimates. Verify structural, electrical, plumbing, roofing and code-sensitive work with qualified professionals and local requirements.

Frequently asked questions

How do I calculate concrete for a slab?

Multiply slab length by width by depth after converting all dimensions to compatible units. The result can then be converted to cubic yards for ordering estimates.

Why is concrete measured in cubic yards?

Concrete is a volume material. In the United States, ready-mix concrete is commonly planned and ordered in cubic yards rather than square feet.

Should I order exactly the calculated amount?

The calculated volume is a planning baseline. Actual jobs can require extra material because of subgrade variation, forms, spillage or measurement differences; confirm the order quantity with your supplier or contractor.

What if I am using bags instead of ready-mix?

Use the Concrete Bag Calculator to estimate bag quantities from the required concrete volume. For a slab-specific workflow, see the Concrete Slab Calculator.

Related concrete & masonry tools

Worked example and practical checks

For a slab 10 ft × 10 ft × 4 in, convert 4 in to 0.333 ft; volume is about 33.3 cubic ft or 1.23 cubic yd. Check the slab thickness and subgrade before ordering.

How to use the result responsibly

Use consistent units and check your measurements at the site. Round purchase quantities up to full packs where necessary. This calculator is a planning aid, not a substitute for supplier specifications, site inspection, or a qualified professional where safety and building codes apply.

Measure every pour section

Calculate steps, pads and thickened edges as separate rectangular volumes, then add them. Verify thickness in the same units as length and width before converting to cubic yards.