Lumber

Lumber Linear Feet Calculator

Estimate total linear feet of lumber from piece count and board length, with practical guidance for stock lengths, cuts and waste.

Use the Lumber Linear Feet CalculatorEstimate total linear feet of lumber from piece count and board length, with practical guidance for stock lengths, cuts and waste.
⚡ Instant result✓ Free to use↔ Unit friendly

Calculator

● LIVE
Before you calculateMeasure the finished project dimensions. Use manufacturer coverage/yield values where a product-specific value is requested. Results are planning estimates, so verify quantities before purchasing.

How to use this calculator

Enter the number of pieces required and the length of each piece using the units requested. The calculator totals the linear footage. Use that total to plan stock purchases, then account for the lumber lengths your supplier actually carries and any cutting waste.

Formula

Linear feet = board length × quantity; cost = linear feet × unit price

Example and planning notes

If a project needs repeated pieces, the total linear feet is only the first step. A cut list may fit efficiently into standard stock lengths, or it may create offcuts that increase the amount you must buy. Knots, damaged ends, grain selection and miter cuts can also affect usable yield.

Important: Results are estimates. Verify structural, electrical, plumbing, roofing and code-sensitive work with qualified professionals and local requirements.

Frequently asked questions

What is a linear foot of lumber?

A linear foot measures length only. One linear foot is 12 inches of board length regardless of the board’s width or thickness.

How do I estimate lumber from a cut list?

Add the required lengths of all pieces to get a linear-foot total, then plan those cuts against available stock lengths and include allowance for saw kerfs, defects and offcuts.

Is linear footage the same as board feet?

No. Linear footage measures length, while board feet measure lumber volume using thickness, width and length. Use the Board Foot Calculator when volume is the quantity you need.

Should I add waste when buying lumber?

Usually yes. The appropriate amount depends on the cut list, stock lengths, lumber quality and project detail. Final purchasing should be based on an actual cutting plan where possible.

Related lumber tools

Worked example and practical checks

Build a cut list by actual board length and quantity, then compare against available stock lengths. A 10 ft board cannot always yield two 5 ft pieces after accounting for saw kerf.

How to use the result responsibly

Use consistent units and check your measurements at the site. Round purchase quantities up to full packs where necessary. This calculator is a planning aid, not a substitute for supplier specifications, site inspection, or a qualified professional where safety and building codes apply.

Use a cut list

List the required finished lengths and quantities before buying stock. Account for saw kerf, unusable ends, knots and the difference between nominal and actual dimensions.